came the solution for those areas where the grass can not grow because of the intense traffic of pets, people or vehicles, excessive shade, low humidity, and any other reason, concrete blocks that allow grass to grow through the lattice, forming a grid that ends hiding the cement allowing and an easier maintenance of soil .
Each block measures 0.40 x0, 40 cm and m2 is covered with 6 units. Its thickness is 10 cm, allowing placement without folders, or subfloor, or waterproofing, which greatly reduces the labor time as well as the cost of work completed.
How do you put the blocks "
Floor Green
? Floor Green 
Step 1: Dig the soil to a depth coincident with the thickness of the block (11 cm) across the sector to cover.
Step 2:
Compact, the rods, determining levels and suitors in order to drain water from rain or irrigation
.
Step 3: Place
totally wet sand at a depth of about 3 cm. It is important that the sand this very saturated with water and that is what will help accommodate the blocks to each other and not moving again.
Step 4: Place the blocks
one after the other, stepping over them as they are positioned to achieve the perfect accommodation on the wet sand. Step 5: Apply fertile ground in each hole in the blocks, dipping to as much as possible to level the land. Then sow seeds or pieces of grass in each space. Water thoroughly until the growth of what is planted. If a dry area where the grass is impossible gravel or pebbles can be used instead of soil.
More info: www.bloquesparacesped.com.ar
0 comments:
Post a Comment